For freshly paved concrete surfaces
PaveCoat Cure & Seal is a penetrating, solvent-based, acrylic concrete sealer designed for “same day” application. PaveCoat Cure & Seal can be applied directly to green curing concrete which will assist in water retention and improve cure strength.
PaveCoat Cure & Seal should not have a gloss finish. Should a gloss finish be required, apply an additional coat of PaveCoat.
Typical Uses
Same day concrete sealing
Freshly poured concrete protection
Dust protective coating
Features
Improves the curing efficiency of concrete
Reduces concrete salt ‘efflorescence’ on coloured surfaces
Provides greater wear resistance and durability
Improves colour retention of coloured concrete
Prevents surface dusting
Suitable for a range of smooth and rough surfaces
Excellent surface penetration
Ideal for faux brick, without additional thinning
Application Guide
For detailed substrate preparation and application steps, please download the full application guide.
Preparation
PROVIDING THAT the concrete surface is firm and resistant to light foot traffic, PaveCoat Cure & Seal can be applied. Ensure the surface is clean and not saturated with moisture.
NOTE: PaveCoat Cure & Seal assists in moisture retention to improve the concrete curing process, next day sealing with this product IS NOT RECOMMENDED.
If same-day sealing is not practical, Nutech Paint recommends allowing the new concrete surface a minimum of 7 days cure prior to application*. PaveCoat is the recommended sealer.
Refer to the relevant TDS for appropriate preparation and application instructions.
*Subject to weather, temperature, concrete strength and other factors.
In winter, concrete will remain cold and wet on the surface for up to 7 days. Sealing of this surface, in these conditions with PaveCoat Cure & Seal IS NOT recommended.
Equipment
Airless Spray, Roller or Brush
Conditions
10°C to 30°C ambient, dry conditions.
Do not apply if; Rain is likely within 12 hours, it is late in the day or early in the morning. Failure to observe these directions can result in coating damage and surface clouding.
Application
PaveCoat Cure & Seal has been developed for Same Day Sealing (Including slate or stenciled concrete) PROVIDING THAT the concrete surface is firm and resistant to light foot traffic.
Ensure the surface is clean, and not saturated with moisture. HOWEVER, as PaveCoat Cure & Seal assists in moisture retention to improve the concrete curing process, next day sealing IS NOT RECOMMENDED.
If same-day sealing is not practical, Nutech Paint recommends allowing the new concrete surface a minimum 7 days cure prior to application*.
*Subject to weather, temperature, concrete strength and other factors. In winter, concrete will remain cold and wet on the surface for up to 7 days. Sealing of this concrete IS NOT recommended until the surface has started to whiten, indicating adequate curing.
For further technical information regarding this product, refer to the Technical Data Sheet link on this page.
Apply 1 even coat
For gloss finish, apply an additional coat of PaveCoat
